See our stickies, there are links to the info you require

 

Hi Dave and thanks for your swift response..

Actually I got lost on the stickies.. can you guide me which one and which post I can find these wiring diagrams on ? Please

 

Errrm bearing in mind we all have other stuff to do, you need to do some detective work

............... In our Stickies ......................... "Technical Service Bulletins and Wiring Diagrams" by @pinkster might be a good place to work from

HTH,

 

Thanks mate.. I'm digging now

Very Much appreciated

 

One last question here.. as I'm getting a used rear SAM to install it .. does it need to be re-programmed ? Or it should work fine.. at least the normal fuses..

 

Hi,

It will at very least require "Version Coding" checking and adjusting if necessary with SDS.

Depending upon Donor SAM Cars spec and your own car spec.
Identical items like Fuel Gauge, Fuel Pump etc etc will all work, but if for example your car has options like say a Rear Window blind etc etc these things may not work, and you could well get issues if you don't have it Coded correctly

HTH,

 

thanks and this is great,

im still getting challenges to trace the wire from front SAM to rear SAM to the ( fuel gauge , fuel pump and reverse lamp ) i couldnt get the network diagram on how the wires from these three systems are going to the REAR sam to the main one..

regards

 

I do not know for certain, but I would say that those 2 SAM's communicate via the CAN Bus, (likely Body CAN) and therefore, like most things on these Cars there is no "Hard Wiring"

All Cars will have Hard Wiring from / to the REAR SAM to Fuel Pump, from Fuel Level Sender, and to Rev Lamp because ALL Cars have those items fitted

Fuel Gauge info will be transmitted from Rear SAM to ICM via CAN, and the Reverse Lamp "on / off" signal goes from TCU, (or maybe ESM) to Rear SAM via CAN not via hard wiring
Similarly ME "authorise" Fuel Pump info goes to Rear SAM via CAN

HTH