Mercedes-Benz Forum banner

Wire with no connector behind cluster

1011 Views 5 Replies 3 Participants Last post by  milosz87
I am in the process of removing my instrument cluster to clean it, and have it removed except for one white wire coming out of the center at the bottom. What is the solution to get this little guy loose?


1990 190E 2.6
1 - 3 of 6 Posts
Cool. Thanks for the reply. Is this best done from the cluster hole or from underneath the dash?

Thanks again.
There is a wire that comes from the rear of the outside temperature gauge LCD panel that is not connected anywhere close to where the others are. I removed the knee bolster and was able to locate where the wire connects on the bottom. It is white underneath the exterior insulation and exits the cluster with two additional harnesses, in which both that disconnect right behind the cluster. I assume this is for the temperature reading that goes to the outside sensor.

It has an unusual looking connector and connects to a panel that is mounted underneath the dash.
1 - 3 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.