Mercedes-Benz Forum banner

Wind Deflector Latch

449 Views 4 Replies 2 Participants Last post by  rudeney
One of the two hold down latches on my wind deflector is missing. The deflector stays in place with just one, but I would like to have both for a little more security from having it fly up. I browsed the Internet but to no avail. I may have to end up fabricating one. For those who have never used a wind screen or deflector the screen fits over the rear seats and comes up at 90 degrees behind the front seats. The two latches fit inside hole where the rear seat belts come out of the back of the rear seats.


See less See more
1 - 2 of 5 Posts
Your best bet might be finding a whole deflector that's in rough condition being sold cheap that has at least one latch. Of course if you have a friend with a 3D printer, maybe you could have one made based on the one you have.
Ah, yes, woodworking - the "original" 3D printing! :)
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.