Mercedes-Benz Forum banner
1 - 1 of 3 Posts

· Registered
'01-E320 & 02-ST2
31,798 Posts
If the wheels are the right offset, (it's stamped on the back of them, a two-digit number following the letters "ET") then you can source the proper lug bolts from RAD through Phil at They are the 14mm ball seat atop 12mm threaded shafts, hardened, etc. Great quality, excellent prices.

I don't think I'd be too concerned about the size and weight being any unusual stress. The ride quality will probably suffer quite a bit, but if you want the look and aren't jumping curbs the suspension pieces should be fine.

Take care and enjoy the ride,
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.