Problem solved. Used a thin tipped chisel, and after a few whacks with a hand sledge, they popped right out. I think they needed to cool down more. I started this after I had been driving, and the hub was still pretty warm, which may have caused the metal to expand slightly.
Wheel bearing???
I am in the process of replacing my front wheel bearings, and I can not figure out how to get the ring/race out of the inner or outer portion of the hub. I have tried to pry it, and I have tried to force it out with a hammer and flathead. Nothing seems to make it budge. Any advice?
Also if I do get it out, will it need to be pressed back on by a shop, or can I do this?
BTW, vehicle is a 1989 300e.
Also if I do get it out, will it need to be pressed back on by a shop, or can I do this?
BTW, vehicle is a 1989 300e.
1 - 2 of 2 Posts
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mercedes-Benz Forum
BenzWorld.org forum is one of the largest Mercedes-Benz owner websites offering the most comprehensive collection of Mercedes-Benz information anywhere in the world. The site includes MB Forums, News, Galleries, Publications, Classifieds, Events and much more!
Full Forum Listing
Recommended Communities
