[chiroracer]

Got my vacuum door locks working! Still have to adjust the passenger lock. Found the leak by sliding a rubber hose over tube until pressure shot up .Crack was in the driver door gap . had to traction the tube to the rear so the crack was more inside the door to make the repair.

 

[chiroracer]

I fixed my broken windshield washer pump. bench tested good. installed I kept pulling back on blinker stalk and no luck. Forgot the foot pedal. LOL will try again when I go to my garage. Also waiting on powder coat on some 6.5 bundt.
Also have to seal front windshield and probably change out my rear rubber.

 

[chiroracer]

Found the pedal for the windshield washers and tested my rebuilt squatter motor and pick your part reservoir and voila.
strong even blast from all 4 nozzles . Must bring a needle to fine tune alignment

Heres to small victories!!! Figured I would tell you guys. An old crusty racer/mechanic( Pepe Rodriguez) told me in my youth,
"Nobody else gives a shit"

 

[chiroracer]

I drove mine! Sorting out the last of the squeaks and rattles. I am deaf in one ear so I have to have a reluctant assistant for location. rear swaybar bushings look good but noisy.
Engine getting smoother as I drive it but still need to do a plug check to see if there is a single or a suspicious pair that look different. OH and I fixed a wear problem in the driver door handle (not unlocking with key) by spacing out the little finger with beer can shims.

 

[chiroracer]

Got it running on all cylinders with some new plug leads! HUGE breakthrough. Now focused on the squeaking rear swaybar bushings ,driving me batty.

 

[chiroracer]

I broke the nipple off of my cold start injector.
I don't recommend this they are near unobtanium and expensive.
I will use down time to replace my injector seals.