Mercedes-Benz Forum banner

1 - 1 of 1 Posts

·
Premium Member
2004 CLK 240 Coupe
Joined
·
11,377 Posts
Discussion Starter #1
I have not performed this task myself, and I do not have a W215. However, following a request for drawings for this task, I have posted the MB WIS procedures for:

a) Remove/install front engine mounts
b) Remove /install rear engine mount.

Note: These instructions are for MB workshops with suitable lifts. For the front mounts there are instructions for lifting the engine and removing the complete exhaust system. However, reference to the thread below, will show that member Agrat (post #12) did manage the task without doing these steps.

The important torque numbers used with engine 275.950 are shown on the WIS drawings.

http://www.benzworld.org/forums/w215-cl-class/1614844-driver-side-engine-mount-replacement-2.html
 

Attachments

1 - 1 of 1 Posts
Top