Mercedes-Benz Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
Hi guys. I just got some LED's for my dash and the wires go over the top of the wedge and onto the other side. From my research, I assume that this will cause a short. I have researched the modification and am still unsure. Can I just clip the tag end of each wire that goes over the top of the wedge on each wire so that there is only one wire per side? Thanks
 

·
Registered
'86 W123 200, OM617 non-turbo, bastard 5-speed; '95 W202 C250 Diesel, OM605 non-turbo, 5-spd man
Joined
·
4,222 Posts
If the LED doesn't fall out of its base when the wires are clipped, sure.

LED lighting
 

·
Registered
Joined
·
125 Posts
Yes. I went through 4 sets that would start flickering after a few months. After the regulator I haven't replaced any in 2 years.
 
1 - 5 of 5 Posts
Top