Mercedes-Benz Forum banner
1 - 12 of 12 Posts

· Registered
99CLK320
Joined
·
1,483 Posts
Discussion Starter · #3 · (Edited)
I took a picture right after I installed them before they settled in but none after. I can say that the car dropped a strong inch on all four corners very even all around. Never looked slammed just aggressive and the car cornered like a go cart. I've ran it on a road course track and it was really fun. You can install the backs without a spring compressor. put the car on jacks and put a floor jack under the swing arm. remove the center bolt and lower the jack and the rear springs come right out. but you will need one for the fronts. Easy DIY. 150.00 half price. {;o)
 

· Registered
92 190e 2.6 Sportline, 2005 clk55
Joined
·
1,200 Posts
hm..... let me do a little more homwork and ill let you know asap. I have had bad luck with my 190e and vogtland springs. I have tried 3 different sets of springs they sent me and none of them would work for the 2.6.
 

· Registered
92 190e 2.6 Sportline, 2005 clk55
Joined
·
1,200 Posts
the fronts were not strong enough to hold up the car. But that doesnt mean there is anything wrong with the ones you hvae for sale. i am just a little cautious about them now. that us why i was hoping for a pic. can you post the one of right after you put them on?
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top