Mercedes-Benz Forum banner

Swirl flap motor clip.

1227 Views 6 Replies 4 Participants Last post by  2005.E320.CDI.OM648
I bought the 2005 Mercedes e320 cdi with 111,000 on it 2 years ago and it's been an awesome car. But with in the last 2 months it goes into limp mode after a minute of driving or I crack it down. It still drives smooth just no power. I put a scanner on it and I will get code p2015, deleted it a few times but comes right back. I can move the arm of the swirl flaps with a screwdriver with out a problem and moves smoothly. So just thinking it's the motor for the flaps gone bad. Ok I am good with that bc I was going to plug in the resistor to bridge the two wires. But... I cant figure out how the to get the clip off the motor it has to be in the worst spot. Almost as bad an changing an alternator on a new Fiat (kids car and what a crappy design). But any help would be great full. And would it harm the car driving it in limp mode?

1 - 2 of 7 Posts
what do you mean by " the clip off the motor"? are you talking about the electrical connection getting unplugged or getting the actuator arm loose so you can pin the linkage forward?
It was unplugging the electrical connection. Bc you have to squeeze the clip. I have extended needle nose but maybe need angled pliers from the top. I will be lifting it to do the oil change in 2 weeks so might wait to see if I can get my hands on it from underneath. Thanks.
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.