Mercedes-Benz Forum banner

SRS Code -9183 ETR squib resistance is too high

7253 Views 5 Replies 3 Participants Last post by  Dave2302
My first post after I have been searching for a few days. This is a 2004 S500 4matic. Code is 9183 for the drivers buckle ETR squib resistance too high. I scanned it with the icarsoft MBII. Is shows a DTC status as stored. Should it say current and stored? This scanner does not seem to be able to clear these codes?

I pulled the seat belt buckle assembly and sent to MyAirBags in Georgia. They tested and said nothing wrong with it.

The squib wires are the two seperate ones in the yellow plug (yellow/black & yellow/red correct?

any advice??
1 - 1 of 6 Posts
Squib = small explosive (?) device to tighten seat belt in a collision. Be careful.

I use the Mercedes DAS. If it showed the code as STORED, I would clear it and see if it came back. If not, I would do nothing until the DTC reappeared.

No idea what icarsoft does.
  • Like
Reactions: 1
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top