Mercedes-Benz Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
The triangular piece at the end of the seatbelt presenter on my 1993 300CE which the seatbelt passes through has broken. I an trying to determine how I would replace this piece. If I undo the end of the seatbelt from behind the front seat, I cannot figure out how I would get the new piece onto the seatbelt and past the seatbelt clip as the clip appears too large to fit into the triangular opening. Can anyone who has replaced this part offer any suggestions on how to get the new part onto the seatbelt?

I have read in a previous forum that I may need to replace the entire seatbelt as the new seatbelt comes with this part already installed on the seatbelt. However, in another forum I read that this part can be replaced without replacing the seatblet.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top