Mercedes-Benz Forum banner
1 - 12 of 12 Posts

· Registered
MB SLK 230 AMG (1997)
Joined
·
356 Posts
Discussion Starter · #1 ·
PLEASE HELP MEEEE!!!!!

i installed a VDFFB Remote roof controller yesterday, and it worked nice, but today i had to unconnect it, when i did i lowered the roof half the way and dont go up or down! when i try to use the roof button it blinks but nothing happes.. and ASR + ABS light shines..

have tried to disconnect the battery and reset the roof controler but nothing helps...

DAMNIT... please please help me... maybe the Brain on the car is fu**ed but i need atleast the roof up, dont have a garage :(:(:(:(:(:(:(:)

:mad: :mad: :mad:
 

· Registered
MB SLK 230 AMG (1997)
Joined
·
356 Posts
Discussion Starter · #3 ·
hm okey thanks, but my manual is in German :( and i dont understand it.. and the roof is half closed, meaning the roof is in the trunk and the trunk lid is half open, soo i cant reach anything..
 

· Registered
Golf R32 / Prev R170 SLK
Joined
·
6,846 Posts

· Registered
MB SLK 230 AMG (1997)
Joined
·
356 Posts
Discussion Starter · #5 ·
thanks alot for the manual Bazzel.

but how do i get the trunk lid down ? its stuck and doesnt move when i push the button :\ need it down to access the trunk to getthe roof up i guess.. :\
 

· Registered
Golf R32 / Prev R170 SLK
Joined
·
6,846 Posts
With key out of igniton roof "should" drop of its own accord...
Flashing light is normally related to a sensor switch.

Yours sounds like its stuck mechanically. Dont force anything.
I cant help much more being 300,000 kilometeres away

Also contact kit vendor.

Good luck

Bazzle
 

· Registered
MB SLK 230 AMG (1997)
Joined
·
356 Posts
Discussion Starter · #7 ·
Bazzle

do you know any ways to get the trunklid down ? or have a picture of where i can find the sw's .. in the manual i find a way to get the roof emergency closed.. but not an emergency opening.. and to get it open you need access to the trunk, witch i cant since the lid is open like when the roof goes down..

sorry for my bad english :(

thanks for helping me
 

· Registered
Golf R32 / Prev R170 SLK
Joined
·
6,846 Posts
Dont worry about bad english, Im Australian :p

Ive posted an assortment of pix but Im not sure what help they will be. If it is a hydraulic lock?? undoing the bleed allen headed nut on pump "may" make it dop

""CAUTION DANGER""

(you may also loose your arm so have roof propped up and a friend helping when inserting any body parts in there)

Im sorry but that is all I can offer .

Bazzle :eek:
 

Attachments

· Registered
Golf R32 / Prev R170 SLK
Joined
·
6,846 Posts
Thinking about your prob again (dont know why I thoiught the roof was half in the air, its in the trunk isnt it??

Put hand down right hand brush at rear, flick switch a few times, try again?
Thump windscreen surround at right top to jar sw there.??

Bazzle
 

· Registered
MB SLK 230 AMG (1997)
Joined
·
356 Posts
Discussion Starter · #10 ·
Thanks Bazzle! yuo do a great job, I am very thankfull :)

ill check it out tomorrow,,,

i took away the autmatic roof controller today and out the wireing back like it was before i installed it, the same happens, only slow blinking on the roof button, and i cant lower or raise my windows with the windows buttons.. but i can lower the windows when i pull the roof button fast twice? strange or is this normal ?

if its a problem with the roof stoped in a faulty possision is that why windows wont move with the window buttons ?
 

· Registered
MB SLK 230 AMG (1997)
Joined
·
356 Posts
Discussion Starter · #11 · (Edited)
Bazzle

Had the car at a shop today and read out the codes, but they didnt find any errors on the roof, but they told me that the ABS sensor was faulty, can that make the roof stop working ? they said it could make the roof stop acting becouse the car didnt know if it was moving or not when that sensor didnt work, anyone have the schematic for that ABS sensor on the Right rear wheel ?

please i need some advices here :p that N10-3 unit costs 1220 usd :( hope i dont need to replace that
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top