Mercedes-Benz Forum banner
1 - 2 of 2 Posts

· Registered
1972 280SEL
28 Posts
Discussion Starter · #1 ·
Hello All,

I'm in the midst of replacing my sunroof seals. The felt strips on the side were no problem - however the front seal is a bit confusing. It has a metal "clip" that seems to run the length of the seal holding it in place. I can't seem to find any screws or anything that hold the metal piece in place, but I can't seem to pull it out! I'm not sure if it's because of the crusty old rubber it's holding in, or if I'm just missing something.

What is the proper procedure for removing the metal support holding the front seal (108-782-00-98) in place?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.