Appreciate the help. I will do as suggested. thanks.
Replacing ETA gasket
Hi guys, I have a new gasket for where the ETA sits -- how do I take off the old gasket from the intake manifold?-- it is pasted on hard.
Do I have to replace the gasket everytime the ETA is removed? The old one looks good at least visually.
How do I put the new gasket on? Is there a sort of adhesive to apply. Obviously I have never done this.
Thanks for all the help.
Do I have to replace the gasket everytime the ETA is removed? The old one looks good at least visually.
How do I put the new gasket on? Is there a sort of adhesive to apply. Obviously I have never done this.
Thanks for all the help.
1 - 3 of 5 Posts
yes I was worried I would drop the razor blade or something else into the hole. Same experience here -- it didn't want to come off easy and aligning the gasket also took some time - I had to put one screw through the gasket and start the thread then align other holes looking w/ a flash light. Finally got the 4 screws in but haven't yet tightened them. Is there a recommended torque or just hand tighten them?
1 - 3 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mercedes-Benz Forum
BenzWorld.org forum is one of the largest Mercedes-Benz owner websites offering the most comprehensive collection of Mercedes-Benz information anywhere in the world. The site includes MB Forums, News, Galleries, Publications, Classifieds, Events and much more!
Full Forum Listing
Recommended Communities
