Go slowly with the razor blade, and make sure no pieces of sticker fall down into the intake manifold. I ended up putting a shop rag in the manifold inlet. The gasket on mine was, I suspect, original, and man did it put up a fight.
Getting the new gasket into position correctly was tricky too, it kept wanting to move around when I sat the throttle body down on it. This is one where patience is a requirement, at least, it was on mine.
Good luck!
Getting the new gasket into position correctly was tricky too, it kept wanting to move around when I sat the throttle body down on it. This is one where patience is a requirement, at least, it was on mine.
Good luck!
