Mercedes-Benz Forum banner

Replace entire center console and AC controls

343 Views 5 Replies 4 Participants Last post by  ic-racer

I have a 300 SL from 1989. I am starting to prepare a complete overhaul of my car's interior, which ideally would include swapping my current center console.

I have the manual version with "dual zones" (1st picture below), and would prefer (for several reasons) the "advanced" automatic control unit (2nd picture after).

I understand how this will be an expensive and laborious project. :)

At this point I am focus on identifying the main steps and obstacles on swapping the center console and respective commands/buttons, along with the control units behind.

Ideally, I would be first swapping the console and controls, and not install the AC unit (just running it on manual). I am counting as much as possible on getting used spared parts.

The AC part, meaning getting a AC unit and remaining components, I would like to leave it for a later stage, as I am still looking ideally for an electric unit.

Any advice and information would be greatly appreciated!

Current specs
Gear shift Steering part Car Motor vehicle Automotive design

Desired new console:
Steering part Satellite radio Radio Motor vehicle Gear shift
See less See more
1 - 1 of 6 Posts
I hate to upset your plans. What you have is better than what you are looking to change to. The more automatic system has much more OLD electronics, vacuum solenoids, valves, and rubber diagrams which will fail.
  • Like
Reactions: 1
1 - 1 of 6 Posts