[ALephart]

Taking the recommended 1 1/2 turns front nd 2 turns rear did'nt pan out to well. I run out of adjustment at 1 1/2 turn's on the rear. Any ideas? I verified the correct shocks where installed in the right configuration, try again Bazzle!

Aaron Lephart

 

[Bazzle]

Sorry 180 degrees to a turn not 360

Mine are back to 45 degrees front, 90 rear.

BAzzle

 

[SpitzeStrom_Terp]

I noticed that my rear Koni's seemed to have less adjustment room about a month after the install. The fronts still allow for a full 1 and 1/2 turns, but I swear the rears will tighten up to a stop after much less spin from either side.

What would be the cause of this, assuming that they were installed correctly? I also noticed that my rear struts squeak after a rain storm for a few hours when going over bumps..hope nothing is causing them damage.

[I currently have both front and rear on almost the softest setting]