[ted560sec]

Need some help-I have a 1990 560 SEC with "one touch" front power windows-ie just a touch and they go all the way up or down. Suddenly quit working; back windows work OK-fuse Ok. Just both front inoperable. Happened while driver window was going down-stopped halfway. Thanks

 

[ttaleric]

Does the window still work? Or is it the one touch that is messed up?!

 

[damageone]

have you tried to resynchronise the express feature??

 

[ted560sec]

I think it is the one touch that doesn't work. Driver window stopped halfway down--passenger window also does not work but both rear windows work OK Thanks

 

[ted560sec]

No-how do you that Thanks

 

[battlecat714]

ted560sec - 4/16/2006 9:26 PM

I think it is the one touch that doesn't work. Driver window stopped halfway down--passenger window also does not work but both rear windows work OK Thanks

Hmm, that's odd that both front windows would go out...usually it's only one.

 

[damageone]

Did some checking, 126 chassis did not come with factory installed expess windows. Some one has added a relay into the front window circuit to allow this to operate. Normally tis was done by aftermarket alarm installers. the relay could be anyware, but favorate place is under the passenger side floor kick pannel. Hopefully it is fused, ad you can just change the fuse, if not switch it with the relay for the rear and see if it starts working.
Good luck[8D]

 

[ted560sec]

Thanks-problem solved. Aftermarket install -one switch went bad and killed both sides-replaced bad switch and now both sides work