PLEASE HELP, car wont start

851 Views 6 Replies 5 Participants Last post by Jon L, Mar 30, 2007

madmanmerc

Discussion Starter · Mar 29, 2007

i just got my cylinder head rebuilt. put it back on today. i am a novice mechanic, so i tried to do everything right. after installing the head and everything else the car wont start. the motor turns, but it sounds like there is no compression at all. does anyone have any ideas. i am really stuck and any advice would be greatly appreciated. thank you

Save

1 - 3 of 7 Posts

madmanmerc

Discussion Starter · #2 · Mar 29, 2007

anyone please

Save

madmanmerc

Discussion Starter · #5 · Mar 30, 2007

its my 280c. but the motor was changed a few years back to a 250c motor (130 932) motor. before i took off the head i marked the camshaft so i can put it excactly where it was before i took it off. so i didnt play with brining anything to tdc. could that be the prob. thank you very much and please help

Save

1 - 3 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month