Mercedes-Benz Forum banner

P0803 DTC back

3696 Views 9 Replies 3 Participants Last post by  ALephart
The P0803 DTC reared it's ugly head today. Before reseting it this time I took off the hose that goes to the throttlebody on the airbox and revved the motor. The butterfly sat lifeless. I then reset the DTC and repeated reving it and it moved! I still have no idea why the computer reports it as a 1-4 shift solenoid malfuntion but I think I am getting close. Any further ideas?

Aaron Lephart
1 - 6 of 10 Posts
I bought and installed a new airvalve today. Sadly the DTC returned. Any other ideas?

Aaron Lephart
Could'nt I just command the solenoid manually using a scan tool?

Aaron Lephart
I took it to a shop and had them try and manually trigger the solenoid. They confirm it works only some of the time. $30.00 part later I hope it fixes it! I will know more on Monday.

Aaron Lephart
I'll check. Supposidly all that is required is dropping the valvebody located in the trans pan area and replace it.

Aaron Lephart
Just got a call from the shop, it WAS'NT the solenoid. It's not the EGS, but rather whatever controls that. They had a new EGS and tried that but it performed the same. Now they are literally going wire by wire to find the problem. I did'nt know this car used a C.A.N. system bus, pretty advanced for 1998!

Aaron Lephart
1 - 6 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top