Mercedes-Benz Forum banner
1 - 1 of 1 Posts

· Registered
118 Posts
Discussion Starter · #1 ·
I'm going to be replacing my o2 sensor and when i went to see what would be required to replace it..i saw that there's a protector cover that surrounds it but the wires attached goes into the car through a small hole.. I don't want to pull on it and rip anything out.. What's required?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.