New stereo fit question

817 Views 6 Replies 5 Participants Last post by Real1shepherd, Apr 23, 2015

boater59

Discussion Starter · Apr 21, 2015 (Edited)

Installing a new Kenwood receiver and after getting all the wiring figured out with the Metra adapter 70-1784 harness, I went to put it in with the metal sleeve on and it didn't seem like it fit in the hole/slot?

These are the typical sleeves one gets with a new stereo that the head clips into locking it in the slot.

Do these in fact get installed with the receiver or not?
If yes, is it a matter of fudging it in or maybe filing out the hole a tad?

If by chance not, what holds the receiver in place?

I was at the point of attempting this at dark last night but the skeeters chased me inside. At first it didn't "seem" like it was gonna fit without some encouragement leading me to believe maybe it doesn't. But I haven't been able to search any threads that has the slightest mention of the actual physical receiver insertion step.

I wanna get this wrapped up then tackle my turn signal switch replacement...:givemebeer:

Save

1 - 2 of 7 Posts

LeftCoastGeek

· #4 · Apr 21, 2015

ditto the Pioneer I installed, snug, but it fit. be careful which tabs you bend to secure the sleeve, as in places, the 'wall' of the opening is fairly thick, and if the tab buckles and protrudes into the stereo opening you'll have real trouble getting it in.

I do remember on one single-DIN mount car, I had to use a triangular rat file to clean up the corners of the opening or the sleeve wouldn't sit flat in there. I don't remmeber which car that was.

Save

LeftCoastGeek

· #6 · Apr 23, 2015

oh for sure, sleeves are stereo specific. and a sleeve for a 5 year old brand Z might not fit a new brand Z.

Save

1 - 2 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month