Mercedes-Benz Forum banner
1 - 8 of 8 Posts

· Registered
1995 Mercedes S420
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi everyone,

I am new to this forum and was hoping someone could help me out.

I have a 1995 S420 with less than 70k on it and recently had the check engine light come on. This is a CA car so it has the LED built in for diagnosis.

It flashes 17 times and then 19 times and repeats that.

What does this mean? Can anyone help me?
 

· Registered
95 S500, 02 ML320, 97 S500
Joined
·
885 Posts
17 would be canbus communication issue. pull your computers out and check for corrosion on the contacts and clean with contact cleaner from radio shack.
19 is a tricky one, but in most cases its a leaking vacuum line or fitting somewhere on top of the motor, or at the module on the side of the transmission.
 

· Registered
94 - S500 Cpe
Joined
·
473 Posts
I have a 1995 S420 with less than 70k on it and recently had the check engine light come on. This is a CA car so it has the LED built in for diagnosis.

It flashes 17 times and then 19 times and repeats that.

What does this mean?
A couple questions: Has the wiring harness been replaced??? That's important and if it hasn't, then that's the place to start.

DTC#17 indicates possible deterioration in the signal harness . . CAN bus . . which could mean the wiring harness has NOT been replaced.

DTC#19 means that the Fuel Computer is at its limit and as slowhands wrote, it well could be a vacuum leak. However, in MANY cases, there's no leak and it requires a fuel computer upgrade. More info here.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top