Mercedes-Benz Forum banner
1 - 2 of 2 Posts

·
Registered
78 416 seismic truck
Joined
·
71 Posts
Discussion Starter · #1 ·
For those of you who may want a tow bar- espescially if you need to push/pull another mog. I made this from 1/4 inch receiver tubing and two pintle eyes. The eyes are rated to 5 tons and you can get larger if you are pushing around a U 2450.

Moderator's pick TIP OF THE MONTH
 

Attachments

·
Registered
78 416 seismic truck
Joined
·
71 Posts
Discussion Starter · #3 ·
I didn't think of putting a pin through it. Or for that matter making it with a switchable end to use both ball/ socket/ pintle combo. That might be my next try. The pintle eye is a blank weldable fitting with a wedge on the end. I cut a slot for the wedge in the end of the tubing to fit for a weld.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top