Looking for used H&R Coil-over, does anyone would like to sell their H&R coilver..?
Join the discussion
Recommended Reading
-
Bad camshaft solinoids P0012, 0015 and 0022.
W203 C-ClassSo no check engine light from these codes but for awhile the car would run rough on startup and after a few minutes it would run ok. However it was sluggish like when the balance shaft was bad. So I read the codes and found the codes that are listed in the title. So I changed out three of the...- 0
- 17
-
Front main axle bolt size? C240 2004
W203 C-ClassI thought it was a 26mm bolt. Main axle bolt, the big one u need to remove to pop cv axle out. Bought a 26 mm deep socket but its too small. Is it 28mm? Can someone confirm. Thanks.- 1
- 1K
-
Torquing valve covers
W203 C-ClassI've recently replaced valve cover gaskets but I cannot torque them. Service manual calls for 10 Nm but it is clearly not enough. I've tightened the bolts twice since but valve covers are still leaking slightly on both sides. I had changed the breather hoses and the cleaned the venting holes...- 18
- 4K
-
OBD port
W203 C-Class2006 C280 4 matic. CEL came on but scanner does not detect any codes. I tried my scanner, one at Autozone and one at Advance Auto and none detected any codes. I located the fuse for the Data Link circuit and the fuse was OK. According to another site, the fuse location is #62 located in the fuse...- 5
- 216
-
Brake rotor, caliper, lines upgrade concerns
W203 C-ClassHi, I have a 2005 c240 with stock 16" wheels and wanted to replace and upgrade the discs, brakes, calipers and also move to stainless steel brake lines. I've already purchased Zimmerman 300mm front and 289mm rear discs as both should fit despite being 11mm larger than stock discs. I did a little...- 2
- 129
Join now to ask and comment!