[Ragnian]

I have the following Bosch part number for the IP pump gasket on an OM352:

1411015097 it is coming up as a headlight gasket.

If someone has a chance could they pass me the IP pump gasket number or a cross for it?

Thanks in advance!

 

[tkv000]

There are many OM352's. Mine for instance is the Ultra powerful 353.902, 84ps, I suspect yours is slightly higher? The Engine number would be helpful regardless (we could try your VIN and see what it brings up if you want to PM me)

Do you mean hand pump gasket?

Which gasket?

Item 29?

or one of these?

 

[Ragnian]

Trev,

Agree the amount of OM352 variations is mind blowing...

Anyway yes number 29...it looks like some of the pictures I have seen of it. Just odd that it comes up as a headlight gasket in some places...perhaps I do have the correct number. I copied it down from Sean at EuroTruck...thought I had miscopied.

I will be putting a new IP pump on a SEE engine to drop into my truck.

Any ideas on who to go to, to get one?

 

[tkv000]

Uh...what happened to your engine?????

I would give Scott @ EI a call, he's the go-to (IMHO) Guy for all things Unimog, and especially FLU419 parts.

 

[Ragnian]

Long story but something is not right deep inside it. The engine was low on oil...I had checked it not too long before the bad sounds but either misread something or something else caused me to run low on oil. Will pull the engine apart and find out what happened.

So I got an almost new SEE engine at a great price and a new IP pump for it turned up a bit with larger plungers...so in the end I will have another 20HP or so.

Reminds me I should get a pyrometer as well....if anyone has some suggestions as to which one let me know.

 

[tkv000]

I really like the Auber one dokaTD recommends. They have a port you can put an audible alarm on or use it to fire a relay to turn on a fan or methanol injector (or something like that).

 

[DokaTD]

Aubers work great for sure.

 

[Steve D]

That is the correct Bosch number. The MB number is A 001 074 1680. The part is about $5.00.

 

[krietpiel]

Apparently there are 2 sizes for item 29 depending on IP pump model
one is 205mm long and the other is 209mm long - also, one is 2mm thick whilst the other is 3mm thick - make sure you get the correct one.

 

[Ragnian]

I did not know there were different thicknesses. Going into an OM352 with IP pump that has 9mm plungers.

I got two from Scott at EI, hoping they are the correct thicknesses. So the 2mm goes with the 205mm? And the 3mm goes with the 209mm? What part of the IP pump to I measure?

I can always make one if needed.

Shiny new 135HP IP pump

 

[krietpiel]

Apparently, the 2mm and 209 goes together and then 3 & 205mm for the alternative.
I am guessing it is a version issue (date). Mine is 1980 and has the 209 gasket.
You can get idea by measuring the cover plate.