Mercedes-Benz Forum banner

1 - 2 of 2 Posts

·
Registered
1993 300E 2.8
Joined
·
329 Posts
Discussion Starter #1
The ETA harness -- how to take it off? Is this a separate part available for purchase (in case the insulation has deteriorated which is very likely given how bad the engine harness was) or shold I have to rebuild?

There is a ring around -- does this come off?

I tried a bit of searching but couldn't find how to remove and replace the ETA harness.

Thanks guys for helping.
 

Attachments

·
Registered
1993 300E 2.8
Joined
·
329 Posts
Discussion Starter #2
Answering my own question:
Just found the DIY article (on this site) on rewiring ETA -- so it's not a simple pull out and replace harness.
 
1 - 2 of 2 Posts
Top