Mercedes-Benz Forum banner

Hood will not latch with release lever installed

930 Views 2 Replies 2 Participants Last post by  ikonw8
All,

After replacing my steering column boot (to reduce the road noise in the cabin) and reassembling; I noticed that my hood will no longer latch.

The hood latched fine before, now it doesn't.

If I unscrew the hood release lever under the steering wheel, the hood will latch properly. As soon as I screw the lever in, the hood will not latch.

My thought is that somehow, when the lever is screwed into the dash, the hood release cable must be under enough tension that the latches remain slightly open. Without being screwed in, the tension on the latch is released, and the hood latches correctly.

I cleaned and lubricated the latches, but that hasn't made a difference.

Any ideas? Thanks,

ikonw8
1 - 1 of 3 Posts
That hood release lever assy will come out of the lower dash panel; IIRC it is held on by one or two screws. I would remove it from the panel and see what is hanging it up, its probably just not sitting properly when once the panel is mounted into place.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top