Mercedes-Benz Forum banner
1 - 1 of 1 Posts

· Registered
1990 300SL-24
1 Posts
Discussion Starter · #1 · (Edited)
Hi there, I am from Italy so please forgive my poor english.
I own a '90 300SL-24 and odometer stopped working after a period of alternate work/stop. The speedometer works fine.
I did open cluster and checked stepper motor, it works under AC 12v. My question his: The signal that comes from harness and goes to odometer is the same that goes to speedometer? So in this case the failure is on the board, right?
Thanks in advance.

P.S. obviously i did check the gears and they are ok.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.