Mercedes-Benz Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi everyone,
I am new to the benzworld so forgive me if im doing this wrong. I have a 2000 clk 430 with a dead battery and i cannot open the trunk. I've tried the key and it turns360 degrees with no results. My fob and counsole buttons dont work. Also my radio wont turn on and power locks dont work. Ive jumped it and can start the car but trunk still wont open. I drove 60 miles and still not enough charge to open trunk??? I dont want to drill holes in my car so Any advice would be appreciated.

Thanks
 

· Registered
Joined
·
621 Posts
since you can jump start the car, it sounds like you have something jammed in the latch. You have to enter the trunk from the back seat. Open the first aid compartment. Get your hand into the trunk compartment. You should be able to pull the seat release or grab the cable enough to release the seat. Once you are in, you can work on the trunk latch. Many people keep one seat unlatched so that you don't have to go through this procedure.
 

· Registered
R230 SL350 Presnt, Past - W208 CLK230K 2000, W203 C Class, W202 C Class, W210 E Class, W201 190E
Joined
·
1,556 Posts
glad you got in, but how come you didnt just connect the car to another car?

There are lots of options if you cant get to the battery.

Cigar light to other car.
In engine use the dedicated jump point under platic flap.
Under the car you can also connect to the alternator if all else fails
 

· Registered
Joined
·
621 Posts
glad you got in, but how come you didnt just connect the car to another car?

There are lots of options if you cant get to the battery.

Cigar light to other car.
In engine use the dedicated jump point under platic flap.
Under the car you can also connect to the alternator if all else fails
He says that he was able to jump it...his problem is that a number of systems is not working.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top