No screws. The bar is press fit to a lip behind the sunroof panel. It holds the card tight to that area. Not a great design considering the wind turbulence from the sunroof. I could probably fit it after word but it would depend on the fabric that is used. I know to steer clear of thick foam backed fabric. I may just go with the marine-type vinyl with no foam.
Headliner support bar Q
I’m having my headliner card recovered. On the back lip of the sunroof there is a aluminum bar that runs the length of the sunroof.
It looks like the bar attaches to the roof and the headliner is glued to it..( think) after the card is installed.
My question is, when you have the card recovered, does this piece get glued with the rest? I’m confused.
Also, the little plastic pieces that tuck up into the sunroof right and left. Should I hand those over to the shop who is recovering? .....what a mess that old glue is!!
Thanks.
![2640241]()
![2640242]()
![2640243]()
It looks like the bar attaches to the roof and the headliner is glued to it..( think) after the card is installed.
My question is, when you have the card recovered, does this piece get glued with the rest? I’m confused.
Also, the little plastic pieces that tuck up into the sunroof right and left. Should I hand those over to the shop who is recovering? .....what a mess that old glue is!!
Thanks.
1 - 2 of 7 Posts
1 - 2 of 7 Posts
