Mercedes-Benz Forum banner

Fatal Errors on Display

1222 Views 3 Replies 4 Participants Last post by  Drew
Hello,

I am new on this board. I have had some weird "fatal errors" on the computer display in the car . The messages say "BAS & EPS" to take the car into the workshop. Well, i did and found out that i need a special chip to update my computer. So if anyone has this problem it's because you need to update the computer system. The year of my car is a 2002 C240.

[:X]
1 - 4 of 4 Posts
ESP-BAS

I have the same problem in a european 2002 C220 CDI and I think that it's a bad connection in sensor wires. ¿It's possible?
My vehicle had the same problem. The dealer replaced the wiring harness to the engine c...

My vehicle had the same problem. The dealer replaced the wiring harness to the engine control unit. The BAS/ESP errors disappeared.
No, it's not a special chip...

What they do is either to change the BAS/ESP module, or to update the module's software itself. [:)]

Yes, this problem is quite common to the pre-'02 C-classes. Nothing to be worried about though as it doesn't cause anything to stop functioning permanently.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top