Just for reference, here is the Xentry bulletin related to the balance shaft issue.
For M272 engine (6 cyl), any engine serial number after 2729xx30 468993 is fine.
For M273 engine (8 cyl), any engine serial number after 2739xx30 088611 is fine.
I have ordered the part, did researchers and found nothing. It’s very easy for RWD but at 4Matic, there’s differential and axial shaft limited the space, and, front side is almost no space due to huge V8 engine.
May someone did that and tell me some tricks and tips?
Thanks in advance.
Hi to all,
I have a w211 270 cdi from 2003 since a couple of months. Since a couple of days, my dashboard asking me to perform a D service.withing 30 days.
It's maybe a stupid question but I'm not used with MB maintenance plan... And as I would like to DIY, is there a list of things to do...
so my 2008 E350 is grumbling and whining when turning the wheel when ambient temps are below 55F.
I changed the fluid at 110k have 147k now.
I’ve checked the PS fluid level and it’s full, no leaks, no bubbling or fluid movement with the cap off engine running.
when the engines warm it’s not...
I've changed the transmission conductor plate on a 320 with success. Now I have a 2004 E500 That looks like it needs a conductor plate,(Code says speed sensor). My research shows that you cannot switch the conductor plates like you could with the E320. Apparently, they are serialized to the...
My 2008 E350 with Keyless Go has an unlocking delay when opening the trunk or any door after being locked for an hour or more. Batteries have been replaced in both key fobs and new car battery (no auxiliary batter). Also, if I immediately lock and unlock the doors or trunk, then no issue. It...
BenzWorld.org forum is one of the largest Mercedes-Benz owner websites offering the most comprehensive collection of Mercedes-Benz information anywhere in the world. The site includes MB Forums, News, Galleries, Publications, Classifieds, Events and much more!