[No message]
Drew/Frank - PLS ASK ML MATT TO REMOVE HIS CURRENT AVATAR
1 - 4 of 4 Posts
Frank and Drew....l am in strong agreement with this...This is completely unacceptable!!!!!!!!!Most of us have children, and the inference here, is downright "SICK".......Personally..l want this individual "BANNED" from our site........[
!]
!]
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Can any understand this magic it seems
W163 M-ClassWell guys I had a set of new Zimmermann's disks drilled n brembo pads to put on ml so I jacked it up took drivers side wheel off and locked steered wheels but could not crack the calipers 21 mill bolts so I WD40 few bolts n put wheel back on as before this the brembo 4 pot brakes where rubbish...- 6
- 104
-
Richie32 · updated
-
Wash Oil Covered Valve Cover?
W163 M-ClassI am going to changing the valve cover gaskets but there is a layer of oily crud on them. Is it safe to wash it off at car wash? Is there any place I shouldn't get water or pressured water spray on? Do I need to cover any thing? The coil packs are on the valve cover, are they sealed well? Garden...- 1
- 34
-
ML350 2011 door issue
W163 M-ClassGuys, While I was putting my car door panel back in, I accidentally damage the lock door knob. The stick and the door knob fell off the lock. I was wondering if there is a way to put it back in or I have to buy a whole new door actuator. ☹️☹️- 1
- 33
-
W163 2002 Ml320 Start Error "Red LED Light Not Flashing"
W163 M-ClassI'll start from the beginning. I pulled in my driveway from a 4hr trip. My son moved my car and the brakeline busted but I didn't know it. I went to leave and started backing slowly out of my driveway, applied my brakes to put the car in drive, I had no brakes. So scared without thinking I put...- 92
- 2K
-
BonitaML320 · updated
-
Replaced Ignition Switch and Lock Cylinder?
W163 M-ClassSo I followed everybody's advice (thanks all!). Finally got the ignition switch on separately from the connector, second time around. First time I put both on together, but my key didnt turn. So, I did it how you guys said, separately. Took 3 different guys and 2 days!! Key turned with new lock...- 119
- 2K
-
soloprop77 · updated
Join now to ask and comment!