Air in the system would not cause the light to come on. The sensor is more than likely the issue.
Disconnected SBC for brake job but...
...I opened the drivers door while doing brake job because I needed my work keys and swipe card this morning. Got the RED warning lights after opening the door but no alarms etc. and after shutting the door the car went back to sleep.
I would of had the job done this weekend but the brake pads for the front didn't fit as they should (Wearever Platinum ceramics, listed to fit the 05 e320 4 matic...don't buy these) so had to reorder.
I disconnected the SBC before starting the pad replacement, front & rear with sensors,, got the rears done. I'll finish the fronts then reconnect the SBC.
Will it clear itself after I pump the brakes to seat and put the key in?,,or maybe after a couple of ignition starts?
I would of had the job done this weekend but the brake pads for the front didn't fit as they should (Wearever Platinum ceramics, listed to fit the 05 e320 4 matic...don't buy these) so had to reorder.
I disconnected the SBC before starting the pad replacement, front & rear with sensors,, got the rears done. I'll finish the fronts then reconnect the SBC.
Will it clear itself after I pump the brakes to seat and put the key in?,,or maybe after a couple of ignition starts?
1 - 1 of 11 Posts
1 - 1 of 11 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mercedes-Benz Forum
BenzWorld.org forum is one of the largest Mercedes-Benz owner websites offering the most comprehensive collection of Mercedes-Benz information anywhere in the world. The site includes MB Forums, News, Galleries, Publications, Classifieds, Events and much more!
Full Forum Listing
Recommended Communities
