Mercedes-Benz Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
444 Posts
Discussion Starter #1
Hey, going to be removing the rails and sliders on dads 72 tomorrow and was hoping someone could confirm the size and pitch of the bolts that are used to extract the pins.

I have read in some of the DIYs that it is an M6, but what pitch?

I plan on buying several different lengths and some washers and stuff, but where dad lives theres not an auto parts store, or a home or hardware store in a long ways, and its irritating to say the least to try to get anywhere in that area.

If someone could just confirm the thread/pitch that would be awesome.


Thanks.
 

·
R/C107 Moderator
Joined
·
31,596 Posts
And the tensioner rail pivot pin is the same size.
 
1 - 3 of 3 Posts
Top