Mercedes-Benz Forum banner
1 - 1 of 1 Posts

·
Outstanding Contributor
2005 SL600, (2) 2003 SL500
Joined
·
4,594 Posts
The feed from the brake lamp switch goes to the exterior lamp failure module, then to connector X18 (pictured), and then to the connector at the brake lamp where you are measuring no voltage. So you probably want to check for voltage at X18 between its pin #8 and chassis ground.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top