Mercedes-Benz Forum banner
1 - 1 of 1 Posts

· Registered
bmw 525e 2.7
35 Posts
Discussion Starter · #1 ·
If I get a 2.5 16v but want an economy/lots of low end torque motor, would it be possible to fit the 2.3 16v or 2.2 16v factory cams to achieve this - I guess those motors were made for that and the 2.5 for top end power looking at the specs - any comments? Am I right in saying same motor/heads basically just different bore/stroke/cr/detail?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.