Mercedes-Benz Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
2005 w203, 2013 Town & Country
Joined
·
2,180 Posts
Discussion Starter #1
Hello
this is a very rough foam form study of a gauge pod i want to build in the computer then have cnc machined out. what do you think of the placement, and where else might you suggest addiditional gauges? i have a volt -air fuel gauge set in my ashtray slot, and i do not want a A pillar pod set. these would be for boost and fuel pressure.
thanks
jake[?]
 

Attachments

K

·
Guest
Joined
·
0 Posts
looks good... pretty unique

I would have attached it to the pillar...


looks good... pretty unique

I would have attached it to the pillar
 

·
Registered
2005 w203, 2013 Town & Country
Joined
·
2,180 Posts
Discussion Starter #3
I could

Hello
This is just a rough mock up. I have thought of a A pillar pod, but i dont want it to be too eclipse or cavalier ish. However i could mock up a quick study and see if i like it. Im just not sure that the w123 non cab forward design would support that design with the A pillar almost straight up. Thanks- Jake
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top