B200 rear washer connector query

1215 Views 5 Replies 3 Participants Last post by DEVOURS, May 30, 2017

Jonathan Knowles

Discussion Starter · May 28, 2017

Hi

I found my rear washer was not functioning for some reason. Finally tracked it down to the elbow connector that connects (push fit) on to the pump(?) at the tank. Replaced it and tried again and the pressure blew the connector off again. OK so thats the problem. I looked at the elbow connector and it has a crack log it so it will now not clamp on to the outlet.

Looking at the elbow connector, it is not obvious how (or indeed if!) this connector comes off.

Anyone got a fix for this?

Thanks!

Save

1 - 2 of 6 Posts

DEVOURS

· #2 · May 28, 2017

Any way for you to epoxy the connector tube back on or clamp the fitting back in place..?

Add a pic or 2 of the defective piece and "Fill in your profile"..Top left of this screen..

Save

DEVOURS

· #6 · May 30, 2017

Heat shrink or ty-raps and epoxy might work as the metal clamp (above pic) might not come in a small enough size....or maybe you will be able to find a very small stainless hose clamp..Let us know what works for you..

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month