Mercedes-Benz Forum banner
Cancel

B200 rear washer connector query

1213 Views 5 Replies 3 Participants Last post by  DEVOURS, 
J
Hi

I found my rear washer was not functioning for some reason. Finally tracked it down to the elbow connector that connects (push fit) on to the pump(?) at the tank. Replaced it and tried again and the pressure blew the connector off again. OK so thats the problem. I looked at the elbow connector and it has a crack log it so it will now not clamp on to the outlet.

Looking at the elbow connector, it is not obvious how (or indeed if!) this connector comes off.

Anyone got a fix for this?

Thanks!
Reply
Save
Like
1 - 2 of 6 Posts
J
Connector

Hi

Its actually the connector at the tank end which is just a push fit. I did a quick fix with 3 cable ties and some epoxy.

For a permanent fix, it is not obvious how the connector is fitted onto the tubing. It looks like some sort of heat shrink tubing about 1cm long which goes over the elbow connector and the end of the tube.

Will investigate further unless someone already knows?

Thanks
See less See more
Reply
Save
Like
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mercedes-Benz Forum
BenzWorld.org forum is one of the largest Mercedes-Benz owner websites offering the most comprehensive collection of Mercedes-Benz information anywhere in the world. The site includes MB Forums, News, Galleries, Publications, Classifieds, Events and much more!
Full Forum Listing
Explore Our Forums
W126 S,SE,SEC,SEL,SD,SDL Class R/C107 SL/SLC Class W163 M-Class W124 E,CE,D,TD Class W210 E-Class
Top