Mercedes-Benz Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I have a 02 c230 with an automatic trans. I am having an issue with the trans, car does not move in drive or reverse. When I put the car in neutral it will drive forward with very little power. Car starts no problem there is no lights on, no malfunctions reader doesn't find anything. (not a professional scanner) I have tried replacing the conductor plate thinking that may have been the issue but it didn't change the problem at all. When I shift it feels like its going into gear but wont move. any ideas? maybe the solenoids?
 

·
Registered
Joined
·
1,490 Posts
Maybe the solenoids,,,or
Did you replace the pilot bushing connector and was the plug oily ? If it was ,,have you checked the TCU for oil intrusion ?
 

·
Coupe/Convertible Forums Moderator
Joined
·
18,709 Posts
You need to scan with a tool that reads MBZ codes - not a generic OBDII scanner. iCarsoft i980 and MBII will do this, as will the Autel MD802 Elite. Of course the best tool is MBZ's SDS.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #6
You need to scan with a tool that reads MBZ codes - not a generic OBDII scanner. iCarsoft i980 and MBII will do this, as will the Autel MD802 Elite. Of course the best tool is MBZ's SDS.
I will have to find a better scanner to check it out. Was thinking maybe it could be something stupid that I dont know about.
 
1 - 8 of 8 Posts
About this Discussion
7 Replies
4 Participants
David Sunday
Mercedes-Benz Forum
BenzWorld.org forum is one of the largest Mercedes-Benz owner websites offering the most comprehensive collection of Mercedes-Benz information anywhere in the world. The site includes MB Forums, News, Galleries, Publications, Classifieds, Events and much more!
Full Forum Listing
Top