[itjobhunter]

I installed my HS gears in my hubs and replaced locker seals too, and I am reassembling everything - can anyone tell me if I have the metal seals in the right order in the pic??

 

[tkv000]

Here's some pictures from the manual, not sure if these will help?

 

[needmog]

Here is another exploded view with part numbers and descriptions.

 

[itjobhunter]

I checked the manuals also, but they call everything a seal, and one is copper and the other steel - I THINK I have the order right based on wear marks, but I'd sure like to confirm it!

 

[needmog]

Based on the exploded view, item 47 is the thicker washer of the two and sits to the right, so it looks like that is what you did in the pics as well.

 

[Kraay]

Can someone explain to me what part #29 in needmog his exploded view is? I found that also in my 78 416, together with a little pipe almost at the portal. But i don't know where it belongs because it was loose in the axle..

 

[needmog]

Looks to me like it's a clip that holds part # 35 (seal ring) onto part # 32 (piston)
If you found yours loose in the axle, chances are the seal ring has or will come off as well.

 

[rmontez]

Kraay
"Almost at the portal" Perhaps it's item 23? If so look at the pictures here:

http://www.benzworld.org/forums/unimog/1542777-416-doka-turbo-fast-gear-build-4.html
4th post last picture inside the housing

I don't know about the small pipe.....take pictures.
Rick

 

[Kraay]

Kraay
"Almost at the portal" Perhaps it's item 23? If so look at the pictures here:

http://www.benzworld.org/forums/unimog/1542777-416-doka-turbo-fast-gear-build-4.html
4th post last picture inside the housing

I don't know about the small pipe.....take pictures.
Rick

Yes that is exactly what I mean! Here a couple of pictures:

 

[VON]

That is the portal box vent tube for the rear portals. Like the fronts, the rears need to be vented as well to the center axle housing. Those tubes are to keep the oil from flowing into the portal when the truck is leaning hard to the sides.

 

[Kraay]

Thank you Von! :thumbsup:
I put it in like this, should i put some loctite silicone around the tube or not?