Mercedes-Benz Forum banner

460 replacement sills

875 Views 7 Replies 3 Participants Last post by  MazWest
I'd like to weld new sills onto my 460. Anybody know the part numbers for these, or anything about how to cut off the old ones/weld on the new ones?

Stories from folks who've done this surgery or who know how it's done would be much appreciated.[?]
1 - 3 of 8 Posts
Thanks, Mike.

Unlike those of most of the trucks in that thread..thank goodness, my floor panels are ok.

The part where I'm hurting is in the rocker panels.

Everywhere a hole was drilled (at the factory) for screws to hold the rubber bumper on, rust has started and is spreading.

I sent a PM, and would like to see your pics. That said, I'm sure I'm not the only one who'd like to hear your lessons learned.

1 - 3 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.