Mercedes-Benz Forum banner

1 - 1 of 1 Posts

·
Registered
93 190E 2.6; 82 300 SD Turbo
Joined
·
1,686 Posts
Discussion Starter #1
Hello everyone,

I'm in the middle of a restoration project on my one 300SD..... Looking for some advice on this part of the repair...

OK After digging deeper into the rear jack point..

I need some suggestions on how to best fix this...

The hole-jack point thing is solid. I'm just not sure how to best attach to the bottom of the structure:



As well as this area too:

I think this will be the most difficult/challenging piece to repair:

PS: Dont ask what that stuff that looks eerily similar to expanding foam insulation is....
My dad and my one mechanically inclined friends' ideas...

 
1 - 1 of 1 Posts
Top