Mercedes-Benz Forum banner

2013 SL63 ABC

3902 Views 7 Replies 2 Participants Last post by  OKB
i have got an R231 2013 SL63 with 40,000km

When i bought the SL there is the ABC malfunction warning but it comes on and off.

In the center display screen showing the ABC and G force, during driving i can see the ABC indicator beside the wheel will have the red column showing ABC is active by going up and down

I was ask by the Dealer that the ABC pump and ECU need tobe replaced in which i did.

After all the expensive repairs, the ABC screen in the center console whereby the ABC indicator is not moving even during driving.

But when i engaged the vehicle lift, the ABC indicator shows the car is lifting as the red column indictor will move.

Went back to the dealer and told me that this is normal that the ABC indicator will not move during driving.

Can someome give some advice is this normal?

Maybe can email me some video of the screen during driving as i cant find in youtube so i can argue with the dealer.
1 - 4 of 8 Posts
when you are on high level at a stop, then drive, the car lowers to what ever height it wants, it doesnt matter what button you push, it drives at what height it wants. when you come to slow speed it goes back on hi level.
When you are driving, It does show on the graph what height it is at, but you cant do anything about it
as far as I have noticed, it would not go that low unless you were at a stop, it wouldnt look like that while moving at all
I will check next week. I will drive the car some distance
at stop it is very low line, then when driving it goes up to a little above the o or mid line. when you slow or stop and push raise, it goes up near top line. Then when you drive off it goes to the middle again.
Thne g force markers light as you go into cornering, it shows the pressure against the side or wheel you are cornering against
1 - 4 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top