Mercedes-Benz Forum banner
Not open for further replies.
1 - 1 of 1 Posts

· Registered
1300L Unicat (now sold) and 1750L Doka and U1700
8 Posts
Discussion Starter · #1 ·
Unimog U1700 Full ground up restoration.

Interested in Unimogs, if so would you be interested in owning one of the best customised / restored Mogs in Australia. Our current project is a 1990 model U1700 single cab.

Original specs.
168hp Turbo Diesel 352A 6 cylinder engine
4 wheel coil spring
4 wheel disk brakes
4 wheel diff locks
GVM 12000kgs
GCM 26000kgs
Approx 180L fuel tank
Front and rear diff locks

Original optional extras included.
PTO box with front and rear outputs
Hydrostatic gear box
Power steering
22.5in Rims 455/65R22.5 Tyres (note tires shown in photos are avaiable at an extra cost)

The work / detail completed
Complete strip down every removable part has been stripped blasted and repainted
Chassis, removed and sandblasted
Engine stripped and repainted (original Merc green)
Gearbox soda blasted and repainted (original Merc green)
Diffs soda blasted and repainted
Most bolts have been replaced
All electrical wiring replaced where nesscessary
Air hoses replaced where nesscessary
Cabin removed stripped and sandblasted
Any rust (minor) was cut and replaced with steel not bog
Turret (roof) removed and raised 8 inches for extra head room
Over head console installed
Overhead storage
Stereo GPS housing installed
Original roof vent replaced
Roof rack/ roll cage mounts installed, ready for rack
New front brake disks and pads.
Custom stainless steel guards
Custom fibreglass grill
Cab insulation
Marine grade carpet
Custom trimmed seats
Drivers foot well enlarged
New door cards

The list goes on.

You will not find a better Unimog In Australia (Unless you compare it to our own Doka Cab) which we are also in the process of rebuilding and adding a camper to the back. We can also build a camper / tray to suit your requirments.

We also provide a restoration service if you already own a Mog and want it to look like it did when it rolled off the factory floor..

Our list of customised parts is growing on a dialy bases:-
Fibreglass grills
Customised original seats
Rebuilt KAM air-ride seats
Aftermarket seat mounts
Roof rack/ roll cage
Stainless steel front guards
Rear heavy duty steel guards
Custom trays with 3 or 4 point torsion free mounting system
Raised roof
Overhead console
Stainless steel mandrell bent exhausts, stack or rear outlet
Winch bars / Bull bars
Replacment front center bumper infills
Replacement heater fans

Priced at $75,000
More videos and photos are available on request.
Please phone Daniel on 0414899298 for more details


1 - 1 of 1 Posts
Not open for further replies.