I was searching my W201 CD and on the 1986 Supplement it says:
"A new front torsion bar, repositioned with respect to the engine, has been installed. Due to it's larger diameter of 24mm (22mm at each end), new rubber bushing mounts are required."
The 16V and EVO II only has a 23mm front sway bar so this must be a mistake... right?
Regards,
Don
"A new front torsion bar, repositioned with respect to the engine, has been installed. Due to it's larger diameter of 24mm (22mm at each end), new rubber bushing mounts are required."
The 16V and EVO II only has a 23mm front sway bar so this must be a mistake... right?
Regards,
Don
