Hi I'm new to this forum and as of recently the engine in my 190e 2.3-16v has began to fail, I love the car, don't want to get rid of it and would not mind more power soooo I've been consider an engine swap. I've heard that many m104s would fit well in the car and am wondering how well exactly...
This is my first time getting into the modification scene and I'm planning on doing an engine swap for my 1987 190. I've acquired the engine, however I have yet to acquire the transmission (assuming my current transmission won't suit the M104.99x), parts for the cooling system and other...
First and foremost I'd like to thank the people of this community past and present for your generosity and expertise. You have been an enormous help and I couldn't have gotten as far as I am without you.
Into the thick of it. I have a 1989 190e 2.6 California (Link to VIN info...
Could anyone help me identify this wire?
It's a thicccccccc boi. Red with a green strip.
I don't know where to connect the cable.
One side is connected to this black relay that is connected to the fuel pump relay too.
And if anyone could tell my what this 2 ralays are. Thanks you.
I have read about upgrades for w201 brakes and all the links were dead I looked into what I thought were the right parts I got Cardone A1 19-6245 calipers from stock wise and Zimmerman rotors off FCP both websites checked that they fit a 93 e300 which I found was a reference other people advised...
Ronal R9 Penta Wheels. Set of (4) 7x15 ET35 in the boxes as stored over 10 years ago. Purported to fit W124, W201, W202, W203. These were stripped before I got them. Came from a California Porsche wheel shop.
Pick ups are welcome. Buyer pays shipping.
Hello, I have an issue where my oil is being burnt and I am forced to add oil to the engine every once an a while. I was wondering if anyone knew what could be the issue. On the left side of the engine block there is signs of oil present but no signs of oil on the ground below my car. I could...
As the title says looking for parts or an entire car for a swap from auto to manual.
second, looking for an OEM mosselman turbo kit for the w201 m102 engine. New or excellent condition only.
I’m located on the east coast. Willing to travel within 600 miles of Niagara or figure out shipping...
Hi everyone I’m really hoping I can get some help here because I am lost for what to do now
so my heater inside my Mercedes 190e 2.0 1990 just stoped blowing heat ( blower motor is fine ) it still blows for about 10 seconds hot them goes cold this is what I’ve done
So I have a 1987 190E 2.6 and as you all know it's not exactly a speed demon. I'm a college student so money isn't readily available, but I want to save up to do an m104 swap.
I'd like to know a rough ballpark of how much it might cost (going to buy new trans as well). Also what kind of parts...
Hi! I have a 190e w201 1989 (2.3 i think) swaped to 2.0. The AC is a mess the lines are cut and it seams PO change some coponents.
Any info about the system(wire diagram, where the lines should go, how to clean everything(the inside ofc), (how to test the compresson and other components for...
I bought a 1986 W201 2.0L with a carburetor and the engine is really slow and lost all his power because it was always an old man driving.
Now i have the possibility to buy a 2.3L m111.975 kompressor.
and i know people allready swapped that in a w201.
but i dont know how and what.
Hi everyone, engine in my 190E is dead, probably timing shaft is broken, already have enigne from w124 (M104.992) 3.2 automatic, wanna leave gearbox that's 717.442 manual 5 speed. Will it fit togehter, what I need if so?
Greetings from Poland!
Just started working on my new2me 190e and learning at this very moment to take pictures before disassembly. Also learning electrical diagnosis for the first time, oh boy!
I have the S29/1 connector and the wire colors don't match any manual. Just like life, how can I determine which...